JBDC IMS PULSEMIG 270 Anleitung Seite 21

RESET
Save:
SD card with version V1005 allows using synergic welding for the material and diameters in the chart below:
List of synergic modes (V1012)
Std
Fe Arg CO2 18%
Al Mg 5 Arg 100%
Al Si 12 Arg 100%
Al Si 5 Arg 100%
Cr Ni 308 Arg 100%
Cr Ni 316 Arg 100%
Cu Si 3 Arg 100%
Cu Al 8 Arg 100%
Fe CO2 100%
Information panel
It contains the indices and sub-indices of the circuits and
the software version (HMI, power, SD card ...)
IMS PULSEMIG 270
The PULSEMIG 270 has 2 reset options. The « SOFT » option resets the
machine completely but stores the settings saved in memory. The « TOTAL »
option reset the machine perameters to those when purchased (For this mode
an SD card is needed).
To save a welding program you need to enter a number and a name. (7
letters)
Ø0.6 Ø0.8 Ø1
X X X
X X
X
X
X X
X X
X X
X X
X X
Ø1.2 Puls Ø0.6
X
X
X
Example:
EN
Ø0.8 Ø1 Ø1.2
X X
X X X
X X
X X X
X X
X X
X X
X X
21