AXTON C109 Einbauanleitung Und Bedienungsanleitung Seite 32

5 Make sure you are using a main fuse protection for the +12V-
power input of the amplifier within max. 30 cm of the car
battery and power cables with an amperage adequate cross-section
and main fuse (for details see section E: „Connecting").
6 The GROUND/GND cable (-12V) should have the same cross-
section as the +12V power cable. Make sure to get a good
chassis ground contact, because poor ground contacts are the cause
for most power problems with car audio installations.
Make sure no power, signal or speaker lines are shorting to chassis
7
ground by using rubber grommets wherever a cable has to
pass through any metal part of the vehicle.
Important: Before any wiring, always remove the +12V terminal of
the battery to prevent short-circuiting. The last lead to be connected
in every installation is always the positive +12 Volt terminal of the
battery. Connect this lead only after having completed and checked
all other connections.
32