Blaupunkt BPPT-001 Bedienungsanleitung Seite 6

Screwdriver Safety Warning:
– Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact
hidden wiring. Fasteners contacting a "live" wire may make exposed metal parts of the power tool "live" and could
give the operator an electric shock.
Only Li-ion Battery used in all battery pack
Special Safety Instructions for Battery packet and Charger
If under extreme conditions any electrolyte should escape from the battery, it's essential to avoid contact with skin. If
electrolyte does come into contact with your skin, rinse it off with water. In the event of electrolyte contact with your
eyes, it's essential to consult a doctor.
a) This appliance is not intended for use by persons(including children)with reduced physical, sensory or mental
capacities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their by person responsible for their safety.
b) Children should be supervised to ensure that they do not play with the appliance.
c) Before the use of the charger and the battery packet, read the instruction manual for it carefully.
d) During the charge process, the current used should correspond to the current of the battery
charger.
e) Never let moisture, rain or splashed water reaches the charging location.
f) The ambient temperature must not exceed 40oC. Never expose the device to direct insulation.
g) Only switch off the current when the battery packet has been inserted into the box or has been pulled out of the
box.
h) Storage-battery packet, which are defective or damaged or can no longer be recharged, must be disposed of as
hazardous waste. Hand them over at a special collection point. Never harm our
environment. Do not throw unusable storagebattery packet away into the domestic waste, into fire
or into water.
i) If the electrical cable is damaged, the wire may only be replaced by the supplier or by his repair workshop. Have
repairs carried out only by an authorized specialist only.
j) Use only storage-battery packet, which have been produced by the original manufacturer.
k) Always keep the surface of the charger free from dust and dirt.
l) Insert the battery packet into the charger. Follow the guidelines provided concerning polarity.
m) Always remove battery packet before working on the machine
n) When the battery packet is outside the drill, cover the contacts to avoid short circuits
(e.g. from tools)
o) Protect the battery packet from impacts, and don't open it.
p) Never discharge the battery packet completely and recharge occasionally if not used
for a prolonged period.
Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Health defects resulting from vibration emission if the power tool is being used over longer period
of time or not adequately managed and properly maintained.
WARNING! This machine produces an electromagnetic field during operation. This field may under
some circumstances interfere with active or passive medical implants. To reduce the risk of serious or
fatal injury, we recommend persons with medical implants to consult their physician and the medical
implant manufacturer before operating this machine.
4