Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAFETY INFORMATION! READ CAREFULLY BEFORE USING RECOVERY SYSTEM!
CAUTION! This equipment should only be operated by certified personnel.
SAFETY SUMMARY
The following safety information is provided as guidelines to help you operate your new system under the safest possible
conditions. Any equipment that uses chemicals can be potentially dangerous to use when safety or safe handling
instructions are not followed. The following safety instructions are to provide the user with the information necessary
for safe use and operation. Please read and retain these instructions for the continued safe use of your service system.
SAFETY INFORMATION
Customers respect the tools with which they work. They know that the tools represent years of constantly improved
designs and developments. The customer also knows that tools are dangerous if misused or abused. To reduce risk of
discomfort, illness, or even death, read, understand, and follow the following safety instructions. In addition, make certain
that anyone using this equipment understands and follows these safety instructions as well.
READ ALL SAFETY INFORMATION CAREFULLY before attempting to install, operate, or service this equipment. Failure to
comply with these instructions could result in personal injury and/or property damage.
RETAIN THE FOLLOWING SAFETY INFORMATION FOR FUTURE REFERENCE.
Published standards on safety are available and are listed at the end of this section under ADDITIONAL SAFETY
INFORMATION.
The National Electrical Code, Occupational Safety and Health Act regulations, local industrial codes and local inspection
requirements also provide a basis for equipment installation, use, and service.
The following safety alert symbols identify important safety messages in this manual. When you see one of the symbols
shown here, be alert to the possibility of personal injury and carefully read the message that follows.
Recovery tank contains liquid refrigerant under high pressure. Never over fill recovery tank. Tanks should be filled to a
maximum of 80% of capacity only. Use scale to make sure tank is not over filled.
An over filled tank can explode causing serious injury or death.
ELECTRICAL SHOCK HAZARDS
• Make sure system is electrically connected to a properly grounded power source.
• To reduce the risk of electric shock, unplug the air service center from the outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
• Do not operate the machine with a damaged cord or plug — replace the cord or plug immediately. To
reduce the risk of damage to electric plug and cord, disconnect recovery machine by pulling on the plug
rather than the cord.
An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a
risk of fire and electric shock. If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape as those on machine recovery plug.
b. That extension cord is properly wired and in good electrical condition; and
c. That the wire size is large enough for the length of cord as specified below:
Length of cord in feet:
AWG size of cord:
FUME HAZARDS
• FUMES, GASES, AND VAPORS CAN CAUSE DISCOMFORT, ILLNESS, AND DEATH! To reduce the risk of
discomfort, illness, or death, read, understand, and follow the following safety instructions. In addition,
make certain that anyone that uses the equipment understands and follows these safety instructions as
well.
• Avoid breathing A/C refrigerant and lubricant vapor mist. Exposure may irritate eyes, nose, and throat.
• Stop the recycling process if you develop momentary eye, nose, or throat irritation as this indicates inadequate
ventilation. Stop work and take necessary steps to improve ventilation in the work area.
25
50
16
12
www.mastercool.com
100
150
10
8
English
3
Werbung
Inhaltsverzeichnis
