Troubleshooting - Magicvac P0608ED Betriebsanleitung

®
The MAGIC VAC does not work
• Make sure the MAGIC VAC
ance into it.
• The MAGIC VAC ® will stop automatically if overheated. Allow it to cool down for 15 minutes and try again.
• Check for faults in the power cord or the plug. Should you detect a fault, do not use the
appliance.
®
The MAGIC VAC fails to apply the first seal on the bag cut from the roll
• Make sure the bag cut from the roll is properly positioned as described in the paragraph: "Making bags from
®
MAGIC VAC rolls"
®
The MAGIC VAC does not create a complete vacuum in the bags
• To seal the bag properly, you must make sure that the open end remains completely inside the Vacuum Chamber.
• Make sure that the Sealing Bar, the Sealing Gaskets and Airtight Gaskets are free of impurities. After cleaning
them, put them properly back in place.
• The MAGIC VAC ® bag might have a hole in it. To check it, seal the bag with air on the inside. Dip the bag in water
and apply pressure. The appearance of bubbles means that there is a leak.
Reseal or use another bag.
®
The MAGIC VAC does not seal the bag properly
• If the Sealing Bar overheats and melts the bag, you may have to raise the Lid and allow the Sealing Bar to cool
down for a few minutes.
• The MAGIC VAC ® is built in conformity with current safety standards. Overheating will cause it to turn off auto-
matically. Allow the appliance to cool down for 15 minutes and try again.
®
The MAGIC VAC bag does not maintain a vacuum after being sealed
• Leaks along the seam may be caused by creases, crumbs, grease or liquids. Reopen the bag, clean the upper
inside part of the bag and remove any foreign material from the Sealing Bar before resealing it.
• Check that the bag has no holes in it which have caused air to leak in. Use paper napkins to protect any sharp
edges on the contents of the bag.
®
The MAGIC VAC does not create a vacuum in the containers
• By means of the Connection Hose, connect the container lid (or the Cap Attachment if necessary) to the Air Inlet
of the appliance.
• Leave enough room (at least 3 cm) between the contents and the top of the jar or container.
• If liquids come out during the vacuum-packing process, remember that they must first be chilled in a refrigerator,
not left at room temperature.
• Check that the rim of the jar or container and the universal lid are not damaged in the sealing area. Wipe the rim
and cap clean with a cloth moistened with lukewarm water and repeat the vacuum-packing process.
• Make sure that the gasket of the container cap or the universal cap is set properly in place and is not damaged.
MAGIC VAC ® Executive containers or MAGIC VAC
• Make sure that the arrow on the knob of the container cap is positioned on "VACUUM" before creating a vacuum
in the container and it is positioned on "CLOSED" after a vacuum is formed.
• Make sure that the O-ring beneath the knob of the container cap or the universal cap is set properly in place.
®
MAGIC VAC Family containers do not maintain a vacuum
• Make sure that the gasket beneath the central button (16) of the container cap is set properly in place and is not
damaged.

TROUBLESHOOTING

® has been plugged in properly. Check the electric socket by plugging another appli-
® Universal Caps do not maintain a vacuum
15