Operating Instructions - Hoshizaki Snowflake GII SCR-180BH Bedienungs-, Wartungs- Und Montageanleitung

Snowflake GII
__________________________________________________________________________________
II. OPERATING INSTRUCTIONS
ELECTRICITY
Before connecting the product to electrical power, please verify that the specified electrical power
supply on the product description label corresponds with the local network electrical power supply.
The Product Description label with the specified electrical power supply can be found on the inside of
the cabinet, at the top left-hand side.
Installation of the product must only be undertaken by qualified and trained service personnel as per
the specifications listed in this manual.
Electrical safety of this cabinet can only be valid if its earthed in accordance to current local laws and
regulations.
Earthing of the product is always required.
The manufacturer will not accept any responsibility for any damage arising from improper grounding.
Adhere to all electricity requirements stipulated by the local electrical regulations. The product's
electricity plug and wall socket must have the correct earth connectivity reading. If necessary employ
a qualified electrician.
GENERAL PRELIMINARY CHECKS
Make sure the cabinet is standing on level ground and is upright. If necessary, the adjustable feet of
the cabinet can be used to achieve this. All feet should be in contact with the ground. This is
necessary for the proper operation of the cabinet door.
Do not place the cabinet next to any heat generating devices such as ovens, grills, and deep fryers.
Do not expose to direct sun light. Heat that may be radiated by walls or floors must be insulated with
appropriate insulating material. The cabinet should be placed as far as possible from any heat source.
If the cabinet is re-located, allow three hours before re-starting. Plastic protection or tape should be
removed from the outer surfaces.
EN 6