Fanaway Evo 3 Installationsanleitung Seite 8

INSTALL THE LIGHT BASE TO FAN
1. Loose the screw (1-Fig.5, arrow mark) from base
bracket. Align two slot screws with the keyhole slots
of light base.
2. Turn the light base counterclockwise until slot screws
are firmly at the end of slots.
3. Then secure back screw 1 to the base bracket.
Tighten all three screws. Do not over-tighten.
4. Connect the upper plug from motor to the lower plug
in the light base.
NOTE: there are two arrow marks for screw hole of light
base and screw hole of light base bracket. They are to
identify installation direction of light base
INSTALL THE LIGHT DOME TO LIGHT BASE
Finally install the light dome to light
base via turning it clockwise.
NOTE: There are two arrow marks for
screw head of light base and slot of
light dome. They are to identify
installation direction of light dome.
CHANGE THE BULB
Unplug the lamp socket from circular lamp. Pull the
circular lamp out from spring clips. Finally replace it with
new circular lamp.
Figure 6
8