Hama 00123395 Bedienungsanleitung Seite 4

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
Controls and displays
1. Output
2. Input
3. On/off switch
4. LED display (ampli cation)
5. Variable attenuator G.C.
6. Equaliser S.C.
1. Explanation of Warning Symbols and Notes
Note
This symbol is used to indicate additional information
or important notes.
2. Package Contents
• CATV ampli er
• diese Bedienungsanleitung
3. Safety Notes
• Before opening the device, disconnect the mains plug
and remove the power supply; failure to do so could
result in serious injury or death. This also applies when
cleaning the device or working on the connections.
• The device is not protected against drops or splashes
of water. Do not let the product come into contact
with rain, moisture or other liquids to avoid damaging
the device and to prevent injuries due to short circuits.
• Only connect the device to a mains socket that has
been approved for the device. The mains socket must
always be easily accessible.
• Never use or open a defective device.
• Repair work may only be conducted by an authorized
specialist.
• As with all electronic devices, keep the device out of
the reach of children.
2
4. Climatic operating environment
4.1 Moisture
Choose an installation location where the device will not,
under any circumstances, come into contact with liquids
or other objects (e.g. condensation, ceiling leaks, water
from plants, etc.).
4.2 Heat
• Do not place the device near heat sources (e.g.
radiators, other electric devices, replaces, etc.) and
avoid placing it in direct sunlight.
• Open ames (e.g. candles) are not to be placed on
the device.
• With devices that have coolers or ventilation openings,
it is very important to ensure that these are never
covered or obstructed.
• Also ensure that the device receives generous air
circulation. This will prevent possible damage to
the device as well as re hazards as a result of
overheating.
• It is also very important to ensure that the cable
does not come into contact with heat sources (e.g.
radiators, other electric devices, re places, etc.).
5. Installation notes
• Only connect the device to a mains socket that has
been approved for the device.
• Plan out the installation location for the device
such that the mains plug can be easily reached and
unplugged in case of emergency.
• Choose an installation location such that children
cannot play with the device or its connections
unsupervised.
• The installation location must allow for safe routing of
all connected cables.
• Neither power supply cable nor the supply cable may
be damaged or crushed by any objects.
• In order to avoid damage to the device and any
secondary damage, all devices intended for wall-
mounting may only be mounted on a at surface