lockncharge Joey 30 Cart Bedienungsanleitung Seite 4

Joey 30 Cart
STEP 3 - Routing the cables in the Joey 30 Cart.
Connect your device chargers to the outlets.
Please ensure the switch on silver power strips is
'ON'
Note: Outlets are connected to the ECO Safe Charge
power board. This is controlled by the remote
control provided. (see additional instructions).
Replace the shelf.
"Snap" the device dividers into place.
Remove the plastic cable holder and route the
cables through the cable channels. When all cables
are fitted "snap" down the cable clip.
Insert device base
supports into the shelf.
Install device dividers. Top edge first.
Installation and setup of the device dividers
complete.
"Snap" it down in
place.