Electric Connection; Installation - Glem GHB211IX Betrieb Und Wartung

•EXHAUST MODE: the kitchen vapours are
purified by the metal anti-grease filters and
carried outside through a ducting system.
(Fig. 3A; 3B)
•RECIRCULATING MODE: the kitchen va-
pours are purified by the metal anti-grease
filters and an activated carbon filter (sold
separately), then conveyed back into the
kitchen. (Fig. 3C)
We suggest to have installation carried out
by qualified personnel, in compliance with
all the current regulations and in particular
with the ones concerning air exhaust and
electrical connection.The manufacturer
cannot be held liable for damages caused
by improper installation or if it has not been
carried out according to the state-of-the-art.

ELECTRIC CONNECTION

The appliance has been manufactured as a
class II, therefore no earth cable is necessary.
The connection to the mains is carried out
as follows:
BROWN = L line
BLUE = N neutral
If not provided, connect a plug for the elec-
trical load indicated on the description label.
Where a plug is provided, the cooker hood
must be installed in order that the plug is
easily accessible.
An omnipolar switch with a minimum aper-
ture of 3 mm between contacts, in line with
the electrical load and local standards, must
be placed between the appliance and the
network in the case of direct connection to
the electrical network.

INSTALLATION

The appliance must be installed at a mini-
mum height of 650 mm from an electric coo-
ker stove, or 750 mm from gas or combined
cooker stoves. (Fig.1)
If a connection tube composed of two parts
is used, the upper part must be placed out-
side the lower part.
Do not connect the cooker hood exhaust to
the same conductor used to circulate hot air
or for evacuating fumes from other applian-
ces generated by other than an electrical
source.
MOUNTING THE COOKER HOOD TO THE
WALL
Drill holes A-B-C according to indications
quoted in (fig.1).
Use screws and screw anchors suitable for
wall (e.g. reinforced cement, plasterboard)
for the mounting of the cooker hood. Where
screws and screw anchors are supplied
ensure that they are suitable for the type
of wall where the cooker hood is to be
mounted.
Affix the bracket Z to the wall via the drill
holes C
Hang the cooker hood on the wall using the
drill holes A.
Fasten the cooker hood using the fastening
drill holes B.
EXHAUST VERSION
Connect the flange Y to the discharge ope-
ning with a connecting tube Fig.5 (do not
carry out for filter version) .
Thread the upper connector E to the inside
of the lower connector F; hang the two
connectors inserting them vertically on the
cooker hood, unthread the upper connec-
tor E towards the top, locking it in with the
appropriate screws in the drill holes G of the
bracket Z (fig. 7) previously affixed to the
wall via the drill holes C (fig. 1).
RE-CIRCULATING VERSION
In order to transform your cooker hood
from the exhaust version to the re-circu-
lating version, ask your local retailer for
active carbon filters and then carry out the
following instructions.
The filters must be applied to the suction kit
located inside the cooker hood (fig. 6). The
air is replaced in the environment via the
eyelets impressed on the connector E.
OPERATING CHECKS
Check lights and motor start-up on all
speeds.
USE AND MAINTENANCE
It is recommended to switch on the applian-
ce before cooking. It is also recommended
to leave the appliance in operation for 10
minutes after cooking is terminated in order
7