Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Chime mode
If the detector is triggered in chime mode, the chime will sound immediately. After the chime sounds, there is a short delay before the chime will sound again. To disarm
the detector, press the disarming button on the remote control.
Panic alarm
For an immediate alarm with no delay, aim the remote control at the front of the detector. Simultaneously press and hold the arming button and the disarming button
for 2 seconds. The alarm will sound. Release the arming button and the disarming button. To deactivate the panic alarm, aim the remote control at the front of the
detector and press and hold the disarming button until the alarm stops.
Entry and exit delays
If the detector is armed, it will enter an arming delay of 45 seconds. The LED indicator will flash. After the arming delay has elapsed, the detector will beep once to
indicate that it is armed. If the detector is triggered, the alarm will sound with a 30-second delay. If the detector is not disarmed within 30 seconds, the alarm will sound
at full volume. To disarm the detector, press the disarming button on the remote control.
Technical data
PIR motion detector
Battery type
Battery standby time
Detection range
Detection area
Operating temperature
Relative humidity
Alarm mode
Noise level
Alarm duration
Entry delay
Exit delay
Re-trigger delay
Chime mode
Noise level
Chime duration
Re-trigger delay
Remote control
Battery type
Battery standby time
Transmission range
Transmission area
Operating temperature
Relative humidity
Safety
•
Read the manual carefully before use. Keep the manual for future reference.
•
Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
•
Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.
Battery safety
•
Use only the batteries mentioned in the manual.
•
Do not use old and new batteries together.
•
Do not use batteries of different types or brands.
•
Do not install batteries in reverse polarity.
•
Do not short-circuit or disassemble the batteries.
•
Do not expose the batteries to water.
•
Do not expose the batteries to fire or excessive heat.
•
Batteries are prone to leakage when fully discharged. To avoid damage to the product, remove the batteries when leaving the product unattended for longer
periods of time.
•
If liquid from the batteries comes into contact with skin or clothing, immediately rinse with fresh water.
Cleaning and maintenance
Warning!
•
Do not use cleaning solvents or abrasives.
•
Do not clean the inside of the device.
•
Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
•
Clean the outside of the device using a soft, damp cloth.
AA, 1.5 V DC (3x) (not included)
12 months
6 m
110° horizontally, 70° vertically
0 °C ~ 50 °C
10% ~ 70% (non-condensing)
> 85 dB
30 s
30 s
45 s
5 s
> 90 dB
2 s
2 s
CR2032, 3 V DC (included)
12 months
≥ 6 m
≤ 60°
0 °C ~ 50 °C
10% ~ 70% (non-condensing)
Werbung
Inhaltsverzeichnis
