Final Installation - Grundig 31554 Installationsanleitung

Step 2 – Attaching the Arm to the LCD
IMPORTANT: Make sure the LCD is unplugged before starting this step of the installation and
never lay the LCD face down as this may damage the viewing surface.
Before attaching the arm piece of the mount to your LCD, you must
first determine which hardware to use. Do this by examining the back
of the LCD. If your LCD has a fl at back, use the M4x12mm Bolts
(C). If your LCD has a recessed back, use the longer M4x30mm
Bolts (D) and 19mm Spacers (E). After you have determined the
appropriate bolts, use them to attach the arm piece of the mount to
the back of your LCD. Be careful not to over-tighten the bolts.
Step 3 – Final Installation and Operation

Final Installation

To complete the installation, simply slide the arm piece with your
LCD attached into the wall piece. The plastic tab on the top of the
wall piece should click indicating that the arm piece is secure.
If you need to remove the arm piece, push in on the tab and slide
the arm up. For additional security and stability, insert the security bolt
into the hole located on base of the arm piece and tighten using the
Allen Wrench (G) provided.
Operation and Adjustment
NOTE: Adjustment of your LCD may vary by model.
On most models, the tilt angle of your LCD is adjustable. To adjust
the tilt, first locate the adjustment knob directly behind
the LCD mounting point. Loosen it by turning the knob counter-
clockwise. Adjust the tilt to the desired level and re-tighten
the knob to lock the adjustment in place (see illustration).
Other viewing adjustments can be made by simple moving the arm
into the desired position. If you find that a joint is too tight or too
loose, you can adjust the tightness of that joint. To do this, first examine
the joint If your mount includes an adjustment knob at the
joint, turn the knob clockwise to tighten and counter-clockwise to
loosen. If your mount does not have a knob, use the Allen Wrench
(G) from your hardware kit to tighten or loosen the nut at the joint.
31554-31555 Manual.indd 2 04-06-2009 08:56:40