Technical data
Type
Supply voltage
Max. capacity
Settings
Insulation class
Dimensions
Weight
General safety instructions
1. Before using the machine, carefully read this entire
instruction manual.
2. Before using your new heater, check it, including cord and
plug, for any visible damage. Do not use a damaged heater,
but send it back to your dealer for replacement.
3. This heater is exclusively intended to heat workspaces such
as workshops, garages and storage spaces. Use the
appliance for this purpose only.
4. Under the terms and conditions described in this leaflet, the
heater can be used in wet or damp indoor spaces such as
bathrooms and laundry rooms. A distance of at least 1m
has to be maintained between the heater and baths, taps,
fountains, showers etc.. Make sure it cannot fall into water
and prevent water from getting into the heater itself. If, at
any time, the heater does fall into water, unplug it
immediately! Do not use a heater that has a damp interior
but have it repaired. Never immerse the heater, cord or plug
in water and never touch it with wet hands.
5. The supply voltage and utility frequency, specified on the
machine, need to match those of the socket that is used.
The electrical installation needs to be protected by a
residual current device (max. 30 mAmp).
6. Fully extend the cord before plugging in the heater. Make
sure it does not come into contact with any part of the
heater and prevent it from heating up any other way. Do not
run the cord underneath carpeting; do not cover it with
mats, carpet strips or similar and make sure it is not placed
in any passageways. Make sure the cord cannot be stepped
on and that no furniture is placed on top of it. Do not lead
English
EK3201
V / HZ
230 / 50
W
3000
W
0-1000-2000-3000
IP24
cm
26,5 x 24,5 x 36
kg
4,0
16