Turning The Bench Grinder - PEUGEOT EnergyGrind-150TA Bedienungsanleitung

EnergyGrind-150TMA
REMOVING THE WET GRINDING WHEEL
Unscrew the screws (A-B-C) holding the water tank, after
first draining it via drain plug D.
EnergyGrind-150TBA
12
REMOVING THE WIRE BRUSH WHEEL
Unscrew the six screws (A-B-C-D-E-F) holding the flange.
Proceed as with the 150 mm dry wheel.

TURNING THE BENCH GRINDER

1. DISCONNECT THE MACHINE. Unlock the rotating base using
the two locking bolts (A) located on either side of the base of
the bench grinder (open-ended spanner not supplied).
14
3. Lock the rotating base using the two locking bolts. Make
sure that the bolts are securely fastened before starting up
the machine once again.
16
28
2. Turn the grinder as required, using the
left-hand or right-hand graduations from
0° to 45°.
15
13