Geutebruck Helios/L-IR-10 Handbuch Seite 18

Installation
1 Mount illuminator
2 Mount PSU-1:
Do not position PSU photocell facing
illuminator or other direct light sources
Photocell monitors ambient
lighting conditions
Mount PSU-1 on wall/flat surface with
glands facing down
3 Connect Illuminator to PSU-1:
Installers can extend or reduce lead
length using appropriate cable and
weather proof box
4 PSU-1 connections:
Connect telemetry if required
Telemtery Input
Volt free contact
or TTL input 0-15V, high input impedance.
WArNINg: The PSU current must be
set correctly otherwise the illuminator
could be damaged (see Current Select
Connector diagram page 6)
5 Connect PSU-1 to Mains
CAUTION: Ensure cable glands and
PSU-1 lid are water tight by tightening the
fixings
4
2
3
!
CAUTION:
red = +ve
Black = -ve
(polarity sensitive)
LED Output x2
remote
(Polarity Input
Sensitive)
1
4
5
Mains Input
100V to 230V
AC
Auto-Sensing
!