Drilling; Screwing; Battery Disposal - Westfalia 84 94 37 Originalbetriebsanleitung

Drilling

Before starting to drill select a lower speed to avoid the bit slipping
away from the desired hole location. If the drill-hole is deep, the drill-bit
may become jammed in the hole. In this event a high torque could
damage the drill bit or the drill. If the bit becomes jammed, hold the
impact screwdriver firmly and immediately release the On/Off trigger.
Switch to counter clockwise rotation and use a low rotation speed to
remove the jammed drill bit more easily.

Screwing

Before using the impact screwdriver check whether the screw bit is
inserted correctly. Avoid over-tightening, otherwise the screw head may
be damaged or stripping of the threads may occur.
Set the rotating direction button (5) clockwise. Insert the screw-bit into
the slot in the head of the screw. Hold the screw bit right to the head of
the screw, otherwise the screw or the screw head may be damaged.
Press the screw bit against the screw with a constant pressure while
driving in the screw.
To unscrew, set the rotating direction button (5) counter clockwise.
Insert the screw bit into the slot in the head of the screw. Hold the
screw-bit right to the head of the screw, otherwise the screw or the
screw head may be damaged. Press the screw bit against the screw
with a constant pressure while removing the screw.

Battery Disposal

Run motor until the battery is completely discharged.
1.
For removing the battery, depress the battery release clip (9) and
2.
pull out the battery.
Wrap heavy insulating tape around the battery terminals or enclose
3.
in a sealable plastic bag to prevent possible shorting.
Dispose of the battery through your local waste removal authority.
4.
Operation
14