Honeywell V5004TF Installationsanweisung Seite 6

V5004TF ACTUATOR – INSTALLATION INSTRUCTIONS
Value on
display
Value on
display
Value on
display
Value on
display
MU1B-0655GE51 R0719A
Continuation of table (Display indications and meanings)
Set flow rate in %
Set flow rate in "flow rate"
Current flow rate in %
Current flow rate in "flow
rate"
Compensating the max.
pulse
% flow rate offset
(default: 0)
--
--
Unit of SI (m 3 /h)
Unit of GPM (gal/min)
Linear control curve
Equal percentage control
curve
Modulating range
Modulating range
Actuator rotation
speed 1.5 RPM
Actuator rotation
speed 1 RPM
Actuator rotation
speed automatic
Voltage feedback signal
Voltage feedback signal
Current feedback signal
Current feedback signal
Select using the UP / DOWN buttons and then press the MODE
button to confirm.
Display option during operation:
St permits the display of the flow rate value the controller requires.
Fd permits the display of the flow rate value currently given by the
valve (the progressive change of flow rate values is displayed
during valve stem motion).
Display is for information purposes, only; it is not possible to alter
any values as long as this display is shown.
Select using the UP / DOWN buttons and then press the MODE
button to confirm.
Power failure mode (not available).
Select using the UP / DOWN buttons and then press the MODE
button to confirm.
Select using the UP / DOWN buttons and then press the MODE
button to confirm.
Control range (40).
Control range (818).
Select actuator rotation speed using the UP / DOWN buttons and
then press the MODE button to confirm.
Select feedback signal type using the UP / DOWN buttons and
then press the MODE button to confirm.
6