Blaupunkt SSP701 Bedienungsanleitung Seite 7

SSP701
1. Control Panel
1a. DRY TANK - Information about the empty
water tank (see FILLING THE WATER
TANK)
1b. The "greater-steam-flow" icon
1c. The "ECO steam flow" icon
1d. Control lamp - information about
thermostat operation. When the light
flashes, the steam station heats up.
When it is on continuously, the steam
station is ready for ironing.
1e. Switch
BEFORE FIRST USE
Remove all papers, cartons, and foils protecting the appliance and its parts.
The iron may emit a delicate smoke and smell the first time it is used. It is recommended to warm up
the iron before ironing and use it on an old fabric few times.
FILLING THE WATER TANK
Make sure that the steam station is disconnected from the power supply before filling the tank. Open
the water-inlet cap and fill the tank through the inlet with the beaker.
Do not exceed the maximum level (1.6 l)
IRONING
After filling the water tank, connect the steam station to the power source. Turn off the steam station
by pressing the button (1e). Set the required steam intensity by pressing the steam-intensity button
(SET - 1f ). The chosen setting will be presented by a highlighted symbol within the control panel.
When the steam-readiness lamp (1d) stops blinking and lights permanently, the ironing can start.
Press the steam-release button to release the steam from the iron.
The no-water indicator light will come on after 30 seconds, when there is no water in the tank. Water
must be poured into the tank through the water inlet.
When the ironing is finished, turn off the steam station by pressing the power button for 3 seconds
(1e).
SWITCHING OFF THE STEAM STATION
To switch off the steam station, press and hold the power button for 3 seconds. Any icons and indicator
lamps will go out. Then disconnect the steam station from the power source.
THE ADDITIONAL STEAM-EMISSION FUNCTION
If increased steam emission is required, press the steam-release button twice. The iron will release the
increased amount of steam and then return to a constant level of steam generation.
THE AUTOMATIC SHUT-OFF FUNCTION
The iron automatically switches off when it remains still for 10 minutes. The indicator light and the
sleep-mode icon will flash, and the steam station will emit a sound signal.
Press the steam button to continue ironing. Wait for the indicator light to begin glowing continuously
before ironing.
CLEANING AND MAINTENANCE
Never immerse the iron or the steam station in water. Make sure that the iron and the station have
1f. Set – steam-flow-intensity selection
button (intensive / Eco)
1g. Service button (iron cleaning)
1h. Sleep-mode icon
2. Steam-burst button
3. Soleplate
4. Steam hose
5. Iron stand
6. Water tank
7. Water inlet
8. Steam-hose bands
5