Set-Up - SUPREME SEDONA SDC-S101 Bedienungsanleitung

1. POWER Switch is used to turn the dehydrator on and off.
2. MODE button allows you to choose one of three settings. The lights to the right of the MODE
button indicate which mode is activated.
• When the top RED light is lit, only FAST mode is activated.
• When the bottom GREEN light is lit, only RAW mode is activated.
• When both the top RED and bottom GREEN light are lit, the Two-Stage Sequential
Temperature-Timer is activated (both FAST and RAW mode are activated).
The three settings:
a) FAST mode: The average internal temperature levels will be maintained at the indicated
temperature. As the heating element cycles on and off, internal temperature will rise and
fall. The indicated temperature is the average temperature maintained by the dehydrator.
b) RAW mode: Internal temperature will never go above the indicated temperature. Indicated
temperature is not the average temperature, indicated temperature is the maximum
temperature that the machine will go up to. This is useful for preserving certain vital
nutrients that can degrade at high temperatures.
c) COMBO mode: Uses the Two-Stage Sequential Temperature-Timer to set the two
temperature/time settings. It starts at a higher temperature for a set time (FAST mode)
then automatically drops down to a lower temperature for a set amount of time.
• FAST mode: The first temperature setting and is set at a higher temperature to
encourage more initial dehydrating, less spoiling/fermenting of foods.
• RAW mode: The second temperature setting and is set at lower temperatures for longer
times.
3. SET button has two functions:
• It enables you to set the temperature and the time.
- When initially setting the temperature, press the SET button once and the 3 digit of the
TEMP window will flash.
- When you press the SET button once more, the 2 digit TIMER window will flash.
• Once the temperature and the time is set, the SET button turns on two internal LED lights
while the machine is in operation.
a) Press the SET button once – While the TEMP window flashes, set the desired
temperature by using the 10 or 1 buttons to select your desired temperature.
b) When the TEMP window displays your desired temperature, press the SET button again
to finalize your temperature setting. Your desired temperature is now set up, and the
TIMER window will flash.
c) When the TIMER window flashes, set the desired hours by using the 10 or 1 buttons to
select the desired time, then press the SET button to finalize your choice.

SET-UP

EN
9