Introduction; Remote Communication Over 3G / Gprs Network; Router Connection - METREL A 1622 Betriebsanleitung

A 1622 - 3G and Wi-Fi Router

1 Introduction

Metrel instruments (MI 2892 Power Master, MI 2885 Master Q4, etc.) can be remotely
accessed through Ethernet communication port.
However, on measurement locations where 3G/2G mobile or Wi-Fi communication is
available, this router can be used to establish Communication Bridge to the instrument.
3G and Wi-Fi Router A 1622, is a high-speed Wi-Fi and 3G gateway, for remote access
to the measurement certified and tested by Metrel. In this manual MI 2892 Power
Master is used as example, however other Metrel instruments with Ethernet port are
used in similar way. Two configurations are supported and described:
 Instrument remote communication over 3G / GPRS network
 Instrument remote communication over Wi-Fi network
For other means of connections and configuration please check RUT 230 instruction
manual, provided by OEM manufacturer Teltonika www.teltonika.lt.
Standard set include:
- Router RUT230
- Euro PSU
- 1 x 3G antenna (swivel, SMA male)
- 1 x WiFi antenna (swivel, RP-SMA male)
- Ethernet cable (1.5 m)
- Installation Manual 20 752 818
2 Remote Communication over 3G / GPRS
network

2.1 Router connection

After you unpack box, follow the steps, documented below, in order to properly connect
the router.
Pull out SIM holder by pushing the button (1) and insert SIM card which as
1.
given by your ISP (Internet Service Provider). Insert SIM card into holder (3) and
put it back into the modem (4) Correct SIM card orientation is shown in the figure
below.
Figure 1: SIM card insertion into SIM holder and router
4
Introduction