Connection Check And Further Steps; Remote Communication Over Wi-Fi Network; Router Connection - METREL A 1622 Betriebsanleitung

A 1622 - 3G and Wi-Fi Router

2.4 Connection check and further steps

Assure that your PC is accessing to the internet only by A 1622 3G and Wi-Fi Router
(disconnect other communication channels) and try to access
your browser. If success, router is ready for use with the instrument.
If internet connection over A 1622 3G and Wi-Fi Router is not established:
 Verify hardware connections (SIM card, supply, patch cables, antennas,...)
 Reset Router and repeat setup procedure.
 Check if 3G or Wi-Fi signal is present.
 Contact Metrel for assistance.
Instrument should be now set up in the same manner as described in user manual
under section: "Remote instrument connection (over Internet)". Please check this
section in manual and follow described connection procedure.

3 Remote Communication over Wi-Fi network

3.1 Router connection

After you unpack the box, follow the steps, documented below, in order to properly
connect the router.
Attach Wi-Fi antenna.
1.
Power up router, instrument and PC
2.
Connect devices, as shown on figure below
3.
o Use Ethernet cable to connect Router with PC (use LAN port). PC will be
used to set up router – step 1.
 Alternatively router can be set up over Wi-Fi network, by finding
o Setup the Router
o Use Ethernet cable to connect instrument and router (use LAN port) – step
2.
RUT230_001E42***** (unique for each device) access point on PC.
In that case Ethernet connection with PC is not needed.
Remote Communication over Wi-Fi network
13
www.google.com with