wallas SafeFlame 86D Handbuch Seite 3

86D
INSTALLATION
Fastening of the device
Fasten the oven with the two Figure 6: Installing and tightening the oven 86D into place
fixing strips (Figure 3 (3)),
which have been screwed
onto base (4 universal
screws, 5x16 mm). Make
sure the strips are securely
6
fastened!
Lift the oven onto the fixing
strips so that the back
screws (4) slide into its
grooves (5). Tighten the
screws in the front (6) (2 DIN
933 A2 M5x16 screws)
using a 10 mm fork wrench.
4
5
Connections
Figure 7: 86D connections.
1. Exhaust gas hose. The exhaust gas pipe of the oven is insulated by
using a Ø 45 mm jacket tube. A combination lead-through is used for
the removal of exhaust gases, at which the jacket tube is fastened to
the outermost pipe of the lead-through.
6
2. Lamp and thermostat connector
3. Lamp and thermostat connector (PCB)
4. Control panel
5. Power cord
2
6. Fuel hose
Tighten the hose clamp
1
3
4
5
Solenoid valve
Brown
Black
490048B
3 / ENGLISH
www.busse-yachtshop.de | info@busse-yachtshop.de