wallas SafeFlame 86D Handbuch Seite 2

86D
Cut-out for the installation
The minimum
measurements for the
installation space are
500x400x530 mm (WxHxD).
Do not put other devices in
the installation space. Make
holes, which comprise a
combined area of at least
2
100 cm , at the base of the
cut-out for the cooling air (1).
You must not mount the
85D cooking range and
the 86D oven to the
same installation
opening. 85D and 86D
require an installation
opening of their own.
Figure 3: Measurements for the installation cut-out.
Fastening the control panel
The control panel is fastened
at the desired place on the
tabletop with two screws.
www.busse-yachtshop.de | info@busse-yachtshop.de
There must also be at least
100 cm 2 of free space
above the oven for the
cooling air if the top part of
the oven is to be covered
with a plate, or if it is to be
installed in a closed space
(2). The installation cut-out
should be made of fireproof
material, or it should be lined
with fireproof material.
The installation cut-
out of the oven must
have a replacement
air opening of at
least 100 cm 2 .
2
1
3
Figure 5: Fastening the 86D control panel to the tabletop.
2 / ENGLISH
INSTALLATION
The dimensions of the cut-
out for the control panel are
143 x 40 mm (figure 2). The
length of the control panel
wire is 1.5 m. Heat will
shorten the lifetime of the
electronic equipment. For
this reason, installation of the
control panel immediately
above the oven door is not
recommended.
Figure 2: Cut-out for 86D control panel.
Figure 4: Location of the screws.
3,5x13
490048B