Sehr geehrter Kunde, Wir gratulieren Ihnen zum Erwerb Ihres Gerätes. Lesen Sie die folgenden Anschluss- und Anwen- dungshinweise sorgfältig durch und befolgen Sie diese, um möglichen technischen Schäden vorzu- beugen. Für Schäden, die durch Missachtung der Sicherheitshinweise und unsachgemäßen Gebrauch entstehen, übernehmen wir keine Haftung.
Fernbedienung und Montage Fernbedienung Montage An/Ausschalten DSP Soundeffekte (nur im MicroSD/USB-Modus) Ton stummschalten a Schrauben VOL+ Mehr Lautstärke b Basisplatte Vorheriger Titel c Ständer Play/Pause d Halteklammer Nächster Titel e Gehäuse VOL- Weniger Lautstärke BT Bluetooth-Modus USB MicroSD/USB-Modus AUX AUX-Modus Montageanleitung •...
Musik vom USB-Stick abspielen Schalten Sie den Lautsprecher an. Stecken Sie den USB-Stick in den USB-Port auf der Rückseite des Lautsprechers. Spielen Sie Musik ab. Falls die Musik nicht abgespielt wird, schalten Sie in den USB-Modus. Musik via Audiokabel abspielen Stecken Sie das eine Ende des mitgelieferten Audiokabels in den Kopfhörereingang ihres Geräts.
Dear Customer, Congratulations on purchasing this eqipment. Please read this manual carefully and take care of the following hints on installation and use to avoid technical damages. Any failure caused by ignoring the mentioned items and cautions mentioned in the operation and installation instructions are not covered by our warranty and any liability.
Remote Control and Mounting Remote Control Mounting ON/OFF DSP Sound effects (only in MicroSD/USB mode) Mute volume a Screws VOL+ Increase volume b Base plate Previous Track c Stand Play/Pause d Brackets Next Track e Cabinet VOL- Decrease volume BT Bluetooth mode USB MicroSD/USB mode AUX AUX mode Mounting Instructions...
USB input The Bluetooth Speaker has a USB input located on the back panel. This can be used as an input. Make sure the speaker is turned ON. Push the USB disk into the USB port. Play music from your device. If the music does not play, then switch the mode of the speaker to „USB“.