ELECTROCOMPANIET ECI 3 Bedienungsanleitung Seite 6

Technical specifications ECI 3:
The following technical data where measured on randomized test objects and are typical data.
All measurements are made at 120V / 240V
Clipping point of the amplifier is set to a level where total harmonic distortion (THD) is 0.2 %.
Preamplifier section
Nominal input impedance
Maximum input level
Equivalent input noise
Input sensitivity for rated output single end
Input sensitivity for rated output balanced
Amplifier section
Output Impedance (20 Hz - 20 KHz)
Maximum peak current
THD (measured at 1 KHz half power, 8 Ohm)
THD (measured at 1 KHz -1 dB, 8 Ohm)
Rated output power
10 % change in line voltage will give approximately 20 % change in output power.
8 Ohm
4 Ohm
2 Ohm
Power consumption (no load or signal)
The ECI 3 is DC coupled from input to output.
Dimensions
Width:
Depth:
Height:
Weight:
Specifications subject to change without notice.
// 50Hz / 60Hz
330 kohm
> 10 Volt RMS
< 4 uV
0.6 V
0.3 V
< 0,01 Ohm
> 60 A
< 0,005 %
< 0,006 %
2 x 70 W
2 x 120 W
2 x 160 W
70 W
483 mm
410 mm
115 mm
12 Kg
5
GB USA
- 19 "
- 16.1 "
- 4.5 "
- 26.4 lbs.