Herunterladen Inhalt Inhalt Diese Seite drucken

Speaker Output - ELECTROCOMPANIET ECI 3 Bedienungsanleitung

Balanced integrated amplifier
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
GB USA
How to connect your system
Please read this page carefully and follow diagram 1.
Inputs
Single ended operation:
The left channel is the top row on the rear, marked black.
All inputs are similar regarding sonic performance.
Unused inputs may be shorted to ground, using a RCA shorting plug.
To se the balanced input single ended, connect the ECP5XLR in the XLR
Outputs
REC:
Tape outputs are used for recording.
The source you listen to will be monitored through this output.
The record function is not influenced by the volume control setting, but will be shut off by the
MUTE function.
Never use shorting plugs in outputs.
PRE OUT:
The pre out is dependent by the volume control setting, and MUTE function.
These outputs (balanced and single ended) can be used to control an additional power amplifier.
If more than one amplifier is used, and these amplifiers are DC coupled on the input side, they will
influence on each other when the amplifiers are switched on/off.
To avoid any problem, these amplifiers must be turned on/off simultaneously.
Never use shorting plugs on the outputs.

SPEAKER OUTPUT:

Never short the positive output to ground or chassis.
Switch the amplifier off when connecting the speakers.
How to power up your system
You should always power up your system the following way:
Signal sources (CD Player, tuner etc.) first.
Allow a 30 seconds warm-up before you turn on the ECI 3.
When switching off your system:
Start with the ECI 3, then the signal sources.
2

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis