Assembly; Assembly Instructions; Assembly Instruction Key - THINK GIZMOS TG715 SOUND CONTROLLED WALKING T-REX KIT Bedienungsanleitung

4. ASSEMBLY

4.1 Assembly Instructions

Below are the two most common ways the dinosaur parts connect together.
NOTE: Push the parts together fully so that the bit of wood that sticks out (1) slots into the
square hole on the adjoining piece (2)
To make it easier to slide the pieces together, you can lightly sand the corners to make them
more rounded and smooth. Be sure to assemble as per the assembly instructions, taking
note of the arrow directions for which way parts slot together.
Please note rough and soft ground, such as long grass or carpet, will affect the
walking and turning of the Sound Controlled Walking T-Rex Kit. For best results use
on smooth surface.
For complete building instructions go to page 36

4.2 Assembly Instruction Key

Reference the list below at each stage for some extra help.
Step 1
2
1
From a different angle
1 2
Leg - L
3
Head (5)
direction of arrowhead. (11)
the opening and closing mouth. He bites!
4
Body (6)
(17/18)
Tips: If Sound Controlled Walking T-Rex Kit doesn't walk very well, try inserting
1-3 paper washers (M3) here. (Can be done on both legs).
(18) Connect the motor cable to M2 and cover the connector with D5.
5
Finish
Please polish the edge of the groove to make it easier to
assemble!
Step 2 Step 3
3
Leg - R
Keep the mouth open in a certain angle and then wedge C10 in the
Be careful! Do not put hand or other parts of the body into
Pay attention to the trace line as indicated on the drawing.
6