Herunterladen Diese Seite drucken

Grohe Europlus series Montageanleitung Seite 5

Vorschau ausblenden Andere Handbücher für Europlus series:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
973783.B : i97378gb.fm 2 Wed Jul 9 10:10:26 1997
Application
Can be used in conjunction with:
• Pressurised storage heaters
• Thermally controlled instantaneous
heaters
• Hydraulically controlled instantaneous
heaters
Operation with low-pressure displacement
water heaters is not possible.
Specifications:
• Flow pressure
- min.
- recommended
• Operating pressure-max.
• Test pressure
If greater than 5 bar, fit pressure reducer.
Avoid major pressure differences between
hot and cold water supply.
• Flow rate at 3 bar flow pressure:
33 060 / 33 080
33 065
33 234
33 235
• Temperature:
- Hot water inlet (maximum)
- recommended (energy saving)
- Scalding protection possible by fitting a
temperature limiter (order no. 46 308).
Installation and connection
See fold-out page III, fig. [1] and [2].
Flush pipes thoroughly.
Explanation of fig. [2].
• With handspray inserted, fit spring (A)
onto shower hose from below.
• Screw spray hose to centre pressure
hose (B).
• The Fluidenta Dental Set (order no.
27 800) can be connected to Europlus
33 065 at (C).
• All Grohe single-hole mixers with pull-out
spouts are equiped with non-return
valves.
GB
Fit pop-up waste set (28 910), see fold-
out page II.
Seal plug-hole rim with compound
provided.
Check connections for leakage.
Check fitting for correct operation.
Operation
See fold-out page III, fig. [3].
Cleaning the aerator
See fold-out page III, fig. [4].
0.5 bar
Replacing the cartridge
1 - 5 bar
See fold-out page III, fig. [5].
10 bar
16 bar
Shut off hot and cold water supply.
Change either the complete cartridge (D)
or the seals (D1). Upon refitting, tighten
screws (E) evenly and alternately.
Make sure that the cartridge seals (D1)
ca.13 l/min
engage in the grooves on the housing.
9 l/min
10 l/min
Flow rate limiter
7 l/min
This mixer is fitted with a flow rate limiter,
permitting an infinitely variable reduction in
80 °C
the flow rate by up to 50%, see fold-out
60 °C
page III, Fig. [6]. The highest possible flow
rate is set by the factory before despatch.
The use of flow rate limiters in combination
with hydraulic instantaneous water heaters
is not recommended.
Replacement parts
See fold-out page II.
Use genuine Grohe parts only (available
from your plumber).
Care
For directions on the care of this single-
lever mixer, please refer to the accom-
panying Care Instructions.
2

Werbung

loading