Troubleshooting And Repairs - Starmix AirStar series Bedienungsanleitung

en
1. Take the handpiece out of the holder.
9 The hair dryer is switched on.
2. Put the handpiece back into the holder.
9 The hair dryer is switched off.
Safety features
The hand dryer is equipped with the following safety features:
– Safety cut-off sensor after 35 seconds
– Safety temperature limiter in case of overheating, e.g. if the outlet opening is blocked
The hair dryer is equipped with the following safety features:
– Safety cut-off sensor after approx. 4 minutes, e.g. in case of chewing gum vandalism
– Safety temperature limiter in case of overheating, e.g. if the outlet opening is blocked
– Thermal fuse in case of overheating
5 Conduct in case of emergency
In cases of fire hazard, electrical shock, mechanical damage, unusual operating conditions or misuse, proceed as
follows:
1. Unplug the power cord. With direct connection: Switch off the circuit breaker or unscrew the fuse.
2. Secure against accidental switching on.

6 Troubleshooting and repairs

Malfunction
The device does not start
Air output is insufficient
Do not take any further action; contact customer service instead.
22
Cause
Sensor is soiled
Overheating due to blocked outlet
opening
Only for TH-C1/TB-C1:
The thermal fuse was triggered
Only for TB-C1:
The magnet in the handpiece is
missing
Air intake grille is soiled
Remedy
Remove dirt from the sensor and
wipe with damp cloth
Clean out the outlet opening,
allow the device to cool down
Have the thermal fuse replaced by
customer service
Insert the magnet into the
handpiece
Clean the air intake grille