Device Structure; Installation - Starmix AirStar series Bedienungsanleitung

en

2 Device structure

See Fig. A, B.
1 Device
2 Mounting plate
3 Sensor
4 Outlet opening
5 Air intake grille

3 Installation

Unpacking
1. Take all of the parts out of the packaging.
Scope of delivery:
– 1 device
– 1 mounting plate
– 4 screws
– 4 dowels
– 1 screw for the electric terminal cover
Installing the mounting plate
See Fig. C, D.
CAUTION
Unsuitable installation material!
Risk of injury caused by the device falling down.
Before installation:
1. Check if the screws and dowels supplied with the device are suitable for the surface material.
1. Select a wall with a sturdy, weight-bearing surface.
2. Observe the installation height and minimum distances.
3. Have suitable fastening material to hand for installation on the wall.
4. Use the mounting plate as a template on the wall to mark the drill holes.
5. Drill the holes.
6. Fasten the mounting plate on the wall.
Installing the device
See Fig. E, F, G.
DANGER
Live electrical supply line and device components!
Risk of deadly electric shock in case of contact.
Before performing any work on the device:
1. Unplug the power cord. With direct connection: Switch off the circuit breaker or unscrew the
fuse.
2. Secure against accidental switching on.
Observe the following conditions for the electrical connection:
– Only connect the device to a properly installed grounded socket.
20
6 Locking screw
7 Nozzle
8 Magnet in handle
9 Hose