Connection And Setup; Operation - auna multimedia 10000521 Bedienungsanleitung

Please make sure that the HiFi amplifier is switched off before connecting speakers and other components.
If you are only using two speakers, connect the two main speaker outputs (the outputs with screw terminals) to the
speakers. If you wish to also connect centre and satellite speakers, please use the surround output speaker terminals.
Make sure you connect all the speakers to the correct polarity.
You may now connect HiFi components such as DVD and CD players, cassette players and MP3 players to the inputs
on the rear panel.
For optimal radio reception, the HiFi amplifier should be connected to the house antenna. Alternatively, you may use
the supplied wire antenna with ground wire. Both cables are connected to the two terminals of the tuner section of
the rear panel.
The Auna HiFi receiver offers several possible applications: As an amplifier of HiFi components such as CD players,
DVD players or tape decks, as a receiver for FM radio stations, and as a karaoke amplifier.
Global settings: Adjustment of sound, volume, and balance
The Auna HiFi amplifier provides control of three parametres to optimise the sound of your HiFi system:
With the balance control, you may adjust the left-right balance of the stereo spectrum.
•
With the 'bass' and 'treble' controls of the device, you may boost or cut low and high frequencies.
•
With the 'master volume' dial on the device and the 'volume' buttons on the remote control, you may adjust
•
the overall volume.
To use as a HiFi amplifier:
Connect your stereo equipment to the Auna receiver. The inputs on the back correspond to three buttons on the
front:
Press the 'VCD / Aux' button to select the VCD / Aux stereo signal.
•
Press 'Tape' to select the to tape stereo signal.
•
Press 'DVD' to select the DVD stereo signal.
•
You may also assign different inputs. For example, you may connect an MP3 player with a headphone output to
the VCD / Aux input, or a CD player to the tape input.
To use as an FM radio receiver:
To operate the HiFi amplifier as a radio receiver, please use the supplied remote control. Select channel tuner /
CD. With the Search function on the remote control , you may automatically search the available stations:
Press 'Search' to find the next available station.
•
Press 'Search' a second time to jump to the next available station.
•
Select 'Reset' to go back to the beginning of the radio frequency band.
•
Please note that you cannot perform manual tuning with the device.
To use as a karaoke amplifier:
Various sources can be used for karaoke music. Connect the audio outputs of your karaoke source, e. g. your lap-
top or VCD player, to one of the rear inputs of the Auna HiFi amplifier and select the appropriate channel from the
control panel.
Up to two microphones may be connected via the front inputs. The sound of the microphones may be adjusted as
follows:
The 'echo' control allows you to add and mix an echo effect.
•
'M.Tone' is a 1-band equaliser that can adjust the tone.
•
'M.Vol' adjusts the volume of the two microphones.
•

Connection and setup

Operation

9