Operation; Initial Operation - Klarstein 10033016 Bedienungsanleitung

EN
22

OPERATION

Initial operation

• Carefully remove the heater from the box. Please keep the carton for off-season
storage.
• Make sure the power switch (21) is turned off before pluggin it in.
• Make sure that the heater is completely installed according to the installation
instructions.
• It is better not to use the same outlet with other high power electrical equipment to
avoid overloading the circuit.
Power on
• When the product is connected to the power supply, the red/blue light of the power
indicator (1) lights up.
• Press the start/stop button (20), a short buzz sounds and the unit is switched on.
• The display shows the following settings: The day display (18) shows the day of the
week (default is MON), the hour display (17) the hours, the minute display (16) the
minutes, the temperature display (15) the room temperature, where degrees Celsius
(°C) is normally preset. Auto mode (A) is enabled (alarm events, Auto mode
default), system default is 35°C. If the device suddenly goes out during operation,
the system wakes up again and continues working according to the last setting.
Setting the date and time
1 Press the "OK" (12) and "Set" (13) buttons simultaneously for 5 seconds when
switching on, the day of the week display (18) flashes.
2 Press the up button (10) and down button (1 1) to select the date, confirm the date
by pressing the "Set" button (13). The weekday indicator (18) stops flashing.
3 Now the hour display (17) starts flashing, press the up button (10) and down button
(1 1) to select the hour.
4 After pressing the "Set" button (13), the minutes can be set, indicated by the
flashing minute display (16).
5 Save the settings by pressing the "OK" key (12) and exit the settings menu.
Setting the temperature
• Auto mode is identical to manual mode, default unit is °C.
• When the instrument is switched on, you can select the temperature with the up (10)
and down keys (1 1) when the temperature display (15) flashes.
• If no action is taken for 10 seconds after the setting is completed, the system
automatically saves the setting and exits the menu.