Cabrinha SYNC Installationsanleitung Seite 6

Upper
Option
FITTING THE SYNC BINDING
1. Loosen the binding completely.
2. Place your foot over the arch of the pad.
3. Push the tongue section downwards over the
top of the foot. Note: The sync binding does
not need to be worn as snug as a standard
footstrap.
4. Pull the lace towards the centre of the board
to tighten. Pulling on this angle will mean
an easy adjustment and even distribution of
pressure. Do not pull the lace loop straight up
on a vertical angle.
5. Slide the lace lock down to the lace Ring
and engage the tab by pushing it in towards
the sync upper. NOTE: Under some riding
conditions the lace may slide slightly.
Visit www.cabrinhakites.com for a Sync
Binding Tech Tip Installation and Fitting video.
TO GIVE YOUR BOARD / ACCESSORIES
A LONG LIFE:
SYNC Care and Maintenance.
• Always wash the board components after use
with fresh water and dry thoroughly before
storing.
• The binding and fin mounting screws are
subject to extreme loads and forces. They
should be checked regularly if still tight and if
not, tightened accordingly.
• Ensure that the Sync strap is correctly
adjusted. Riding with an ill fitted strap could
cause injury to the rider or damage to the
strap itself.
Lower
Option
Upper
Option
Upper
Option
Lower
Option