Usb Operations - VESTEL IFD86TI640B/A3 Bedienungsanleitung

Boot Up Picture
Mode
HDMI1 Wake Up
Enabled
USB
Clone to USB
Clone from USB
Copy app cache
from USB
USB Information

USB operations

USB Option
Video Wall Settings
Configures the picture mode preference at power on. If set as Off the last set picture
mode will be used at power on.
If this option is set as Enabled, the Display will turn on with the HDMI input source,
when it is switched on. This feature works based on HDMI 5V signal. When this signal
is active the Display wakes up and when the signal is inactive the Display shuts down.
You can disable this option by setting as Disabled.
If any Scheduler is set or an OPS unit is connected to the Display, this option will be
inactive and can not be set as Enabled.
Note: This feature may not be available depending on the model of your unit.
Copies the database files from the unit to a connected USB device.
Copies the database files from a connected USB device to the unit.
Copies app cache data from a connected USB device to the unit.
Note: This feature may not be available depending on the model of your unit.
Press OK to open the USB information menu screen. Current Total space and Free
space informations of the connected USB device will be displayed. You can also format
the connected USB device using the Format Disk option in this menu (FAT32 format
only).
Highlight and press OK to perform USB operations.
Set as Off to disable the USB ports on the Display. You can also set this option as 5V
to provide 5 volts power over USB. In this case it will still not be available to browse the
USB content via Media Browser feature of the Display.
Press OK to open the Video Wall Settings menu screen. Video Wall Settings, Row
Count, Column Count, Cell and Offset options are available.
Video Wall Settings: Enable or disable the Video Wall function by pressing Left/
Right directional buttons.
Row count: Adjust the number of Video Wall "rows" by pressing Left/Right directional
buttons. The maximum number that can be set is 10.
Column count: Adjust the number of VideoWall "columns" by pressing Left/Right
directional buttons. The maximum number that can be set is 10.
Cell: Each Video Wall unit is called "Cell". Adjust the number of a cell by pressing
Left/Right directional buttons. The maximum number that can be set is 100. In order
to disable video wall function of the unit and display the image in full-screen mode,
the Cell option should be set as 0.
Offset: Offset setting is used to adjust the refractions at the sides of the picture
depending on the bezel thickness between Video Wall units (Cells). The maximum
number that can be set is 50.
For example; For a 2x3 video wall matrix, Row count option should be set as 2 and
Column count option should be set as 3. Numbers of the cells in a video wall matrix will
be determined as shown in the template below. If you are setting the Display, which is
positioned same as the Display with the number 1 in this template, then the Cell option
should be set as 1 for this Display.
English - 21 -