Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
1. Description of the measuring system
Graphics display
On/off button
LED, green to confirm
acquisition of readings,
red to indicate if limits
have been exceeded
Press ON/OFF button to switch the gauge ON or OFF.
Press Function key CAL to start the calibration procedure.
Press Function key MENU to call the main menu.
Press Function key STAT to call the statistics menu.
The command and navigation key block has the following
functions:
Press OK to confirm settings or select menu items.
Press ESC to abort actions, to quit submenus or to navigate
through a batch.
Use ARROW up/down keys to navigate through a menu or to
change settings.
ESC and OK keys assume various functions according to the
currently active menu.
2. Insert batteries and connect sensor
Take gauge and batteries from the soft pouch.
Loosen the screw of the battery compartment to open the battery
compartment lid (e. g. by using a coin).
Insert the batteries into the battery compartment.
Respect polarities (as shown below).
Close lid and tighten screw.
Above the battery compartment screw, a connection for fixing the
hand-strap is located.
The MiniTest 740 can be used with internal or external sensor.
See mounting instructions section 2.1 of the operating manual.
Connection for hand strap
Prism for large curve
radii and large surfaces
Prism for
small curve radii
Coupling ring
Infrared-interface
(IrDA)
Function keys
Command and
navigation key block
Werbung
