Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
03.
Turn on both the monitor and the source.
04.
If your monitor displays an image, installation is complete. If the monitor does not display an image but a ''NO SIGNAL'' message, change
the input channel on the monitor. This can be done by using the ''INPUT'' button on the remote, or by using the input button on the side or
back of the monitor.
05.
Confirm your selection by pressing ''ENTER/AUTO''
06.
If your monitor displays an image, installation is complete. If it does not display an image, please refer to the troubleshooting on page 15.
07.
For touchscreen models only. Connect the included USB cable to to the port on the back of the monitor labelled "Touch" and connect the
other end to the source. The monitor will be recognized instantly if your operating system is supported. Drivers are not necessary.
I N S T A L L I N G T H E M O N I T O R
09 EN
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
Fehlerbehebung
