Beyerdynamic A 2 Bedienungsanleitung Seite 15

A 2 – Operation
Rear View
Input 1, stereo RCA phono sockets for signal sources with high levels.
Input sockets = for the connection of audio sources (CD player, DVD player etc.)
Looped-through output 1 (hard-wired) = for the connection of devices with high level inputs (stereo amplifiers,
active loudspeakers etc.)
At the output 1 you can pick up the audio signal from input 1
loudspeakers or other devices with standard inputs for high levels. As the signal of the input 1
available at output 1, you can listen to the looped-through audio signal via your hi-fi system, even when the
A 2 is turned off.
Input 2 = for the connection of another audio source (CD player, DVD player etc.) or amplifier
µ Voltage selector switch
Position of the switch 230 V: to select the voltage range of 220 - 240 V
Position of the switch 115 V: to select the voltage range of 110 - 120 V
Warning: Before connecting the A 2 to the mains, please check if the selected voltage range corresponds to the
local mains voltage. If you connect the device to a different mains voltage or if you change the position of the
voltage selector switch during operation, a short-circuit can occur inside the device and cause damage to the
device.
¸ Mains connection
The A 2 is supplied with a power cable. If the connector of the power cable is not suitable for the local power
outlet, please purchase an appropriate power cable at your local dealer.
µ ¸
and route it to your stereo amplifier, active
15
is permanently