Operating Determinations; Specifications - auna multimedia 10024341 Bedienungsanleitung

The Auna wireless microphone systems encloses four headsets with transmitters which serve for wireless signal
transmission to the receiving unit. The systems operate within the VHFspectre (174 - 216 MHz). The transmission
range is approx. 100 m and depends on the local conditions. The units were designed for indoor use.
Approval
This wireless microphone system was tested in accordance with the European standards EN 300422-
1 V1.3.2, EN 300422-2 V1.2.2, EN 301489-9-1 V1.8.1, EN 301489-9-1 V1.4.1 and EN 60065:
2002+Al, EN 60065: 2006+All, EN 60065: 2008+A2: 2010, EN 62479: 2010. Consequently, this
product adheres to the R& TTE directive of the European Union and does not need an individual EC
type examination of every member state. The approval number is
In some countries, the operation of this wireless system needs to be approved by the national telecoms regulatory
authority. In Germany, it is necessary to apply for a frequency assignment at the
corresponding branch of the Federal Network Agency (BNetzA). The forms for the frequency assignment can be
found on the website of the Federal Network Agency: www.bundesnetzagentur.de.
Receiver
Size: 21x4x16 cm (WxHxD)
Weight: 1.2 kg
Power souce: AC 230 V ~ 50 Hz
Frequency : 50 - 15000 Hz
Range (max.): 100 m
Distortion factor: < 0.5%
Signal-to-noise ratio (S/N): > 70 dB
Output jack: 6.3 mm
Temperature: (-20~50) °C bis 90%
This wireless microphone set includes four headsets with transmitters and one receiver. The receiver has two
seperate channels which do not interfere with each other. The robust wireless headsets are ideal for karaoke- or
other public adress events.
Getting started
• Connect the receiver to an electric outlet and insert batteries into the transmitters.
• Put the antennae of the receiver upright.
• Switch on the receiver. The operation state will be signalied by the operation display LED.
• Now switch on the transmitters.
• If the receiver receives the signals from the transmitters correctly the LEDs RF will show.
• Single microphone can also being used

Operating Determinations

Specifications

Capability Characteristics
5