Use And Operation - Klarstein Vinsider 24D Handbuch

EN
28

USE AND OPERATION

The Wine Cooler should be placed in a position where the ambient temperature is
between 16-35 °C/60~95 ºF. If the ambient temperature is above or below this range,
the performance of the unit may be affected. For ex- ample, placing your unit in extreme
cold or hot conditions may cause interior temperatures to fluctuate. The range of 5-22
°C/40~72 ºF may not be reached.
Note: When you use the Wine Cooler for the first time or restart the Wine Cooler,
there could be a few degrees vari- ance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the
activation time. Once the Wine Cooler is running for a few hours everything will be
back to normal.
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will
not start.
Control Panel and Functions Models 10029819 & 10032965
POWER: To control this appliance turn on/off. To turn OFF the appliance,
press the button and hold 5 seconds.
LIGHT: To control the inner light turn on/off.
UP: Used to increase (warm) the set temperature by 1 °C/1ºF.
DOWN: Used to lower (cool) the set temperature by 1 °C/1ºF.
Select the temperature display setting in Fahrenheit or Celsius degree.
°C/°F To change the temperature from Fahrenheit to Celsius or from Celsius to
Fahrenheit, press the UP and DOWN buttons at the same time for 5 seconds.
• You can set the temperature as required by pressing the UP or DOWN button.
When you press the two but- tons for the first time, the LED readout will show the
original temperature set previously (the temperature preset at the factory is 12
°C/54 ºF).
• The temperature will increase 1 °C/1ºF if you press the UP button once or the
temperature will decrease 1 °C/1ºF, if you press the DOWN button once.