Setting The Walk And Talk Mode - Siemens Gigaset SL 1 Bedienungsanleitung

Using several handsets
Activating the room monitor function and entering the 'call to' number for
the first time
Step 1: Open the input field: v; s
Step 2: Activate room monitor: r (in the Room M.: line, select On)
Step 3: Enter the destination number: s (to the next line);
Enter internal number: INT s (select handset)
Enter external number: ~;
Step 4: Set the sensitivity: if necessary press s (to the next line); r;
The room monitor function is now activated.
Once the room monitor is activated, switch directly to the room monitor setting with v
(open menu).
Deactivating the room monitor
You can deactivate the room monitor remotely (depending on the base). Take the call
from the room monitor and press O R. The room monitor function will deactivate
around 90 seconds after the call ends. The room monitor will make no further calls. The
other room monitor functions on the handset (e.g. no ringer) will remain activated until
you press the display key
To reactivate the room monitor function with the same telephone
i
number, you must turn on the activation again and save with

Setting the Walk and Talk mode

The Walk and Talk function allows two handsets (maximum range 300 metres) to call
each other no matter how far they are from the base.
Precondition:
Both handsets have been registered to the same base (recommended for the room
◆
monitor function) or
Both handsets are registered to different bases and both are set to Best Base
◆
(page 8) or
One of the handsets is not registered to any base and the registered handset is set
◆
to Best Base or
Neither handset is registered to a base.
◆
In Walk and Talk mode the handsets cannot be reached by incoming calls. The handset
operating times are greatly curtailed.
20
Add. Features
à
(open menu);
on the handset that is in the baby's room.
Off
;
OK
Room Monitor
Edit
or:
OK
OK
Save Entry
Save
OK
.
.
Save