On The Handlebar; Wear And Tear; Changing The Brakes; Changing The Wheel Spring - Micro Mini2go Deluxe Gebrauchsanleitung

On the handlebar

1. Attach the silicone band
2. Make sure that the rubber protection is securely attached to the holders (see Fig. W and X).
3. Wrap the rubber ring diagonally around the rod and attach it to the holder on the bulb (see Fig. Y).

Wear and tear

Changing the brakes

1. Unscrew the eight screws
2. Remove the deck
3. Replace the brake and screw the deck on again.

Changing the wheel spring

1. Loosen the screw
2. Push the wheel spring
3. Put the screw back and tighten it.

Maintenance

Regularly check that all screws are tight, check the condition of the wheels, and replace if necessary. Clean the
Mini2go Deluxe with a soft, moist cloth after each use, and regularly check for visible damage or changes.
to the bulb
17 16
(see Fig. E).
5
(see Fig. F) and unscrew the brake screws with a screwdriver.
6
with a screwdriver (see Fig. G).
7
upwards and replace it with a new wheel spring (see Fig. H).
8
(see Fig. V).
wear and tear
EN
27