Werbung
• Adjust the memory number with . Maximally 8 users of the scale can each
have their own memory number.
• Press . The male-icon blinks.
• Select male or female with .
• Press .
• Set the body height of the user with .
• Press .
• Set the age of the user with .
• Press to confirm. You can check the settings by pressing .
• Press to quit the setting mode and proceed to body fat measuring. The display
shows '0,0 kg'. After ± 10 seconds the RX 7020 switches off automatically.
Measuring
• Press . Wait until the memory figure blinks and your body height is shown.
• Press to proceed to body fat measuring. On the display you will see 'BF' in the
corner below on the right.
• After a few seconds '0,0 kg' appears on the display.
• Calmly step on the scale barefooted. Be sure that your feet and the glass plate
are clean. Put your feet on the contact pads on the left and right side of the plate
(2 for each foot). Your feet must not touch.
REMARK: If you wait too long (±10 seconds) before stepping on the scale, it auto-
matically switches off. In that case again follow the steps above.
• Right after you step on the scale the display shows increasing figures. When your
weight is reached the figures stop increasing and start to blink. This means your
actual weight has been determined.
• Within a few seconds the RX 7020 automatically calculates your body fat and
hydration percentage. On the display you see 'ooooo'. These characters dis-
appear one by one and than the display shows the body fat percentage with the
symbol 'F' and after that the hydration percentage and the symbol 'BW'. These
values are shown 5x alternatively and then the scale switches off automatically.
• On the bottom of the display you will see the key line indication, a series of vertical
bars. This line gives an indication of the level of your body fat percentage, and it
indicates where this percentage stands compared to the statistical norms.
You are regarded as too heavy, normal or too light. You could consider this classifi-
cation as a resource to determine your condition.
REMARK: Every time you switch on the RX 7020 for a new measuring by pressing ,
you can check and/or change the data in the memory before you step on the scale
again.
Use as a normal weighing scale
(without measuring body fat / hydration percentage)
• Carefully tap on the lower edge of the glass plate one time. The display lights up in
weighing scale mode and shows '0,0 kg'.
• Calmly step on the scale (do not jump on it). The display shows increasing figures
that start blinking when the correct weight is reached.
• After a few (±10) seconds the scale switches off automatically.
-18-
Werbung
