MAC Audio Ice Cube 112 A Bedienungsanleitung Seite 5

DEAR CUSTOMER,
We congratulate you on acquiring this MAC AUDIO Car HiFi Product.
Please read these instructions carefully so as to ensure optimum and disturbance-free functioning
of the appliance. Technical modifi cations reserved.
IMPORTANT INFORMATION TO BE HEEDED BEFORE INSTALLATION
· This device is only suitable for connection to a 12-volt system with negative earth.
· Ensure that the input / output cables are far enough away from the power supply cables, as this can
otherwise lead to interference.
· Make sure that the fuse and controls are accessible after installation.
· The performance and reliability of the system depends on the quality of the installation. The system
should therefore be installed by a professional where several speakers or a complex multi-channel
system are involved.
POSITIONING AND SECURING THE SUBWOOFER
Place the subwoofer in a position where adequate ventilation of the amplifi er module is guaranteed. Make
sure it rests on an even surface. The cones and the bass refl ex opening should not be placed directly
against the car's interior walls.
Make sure that the subwoofer is secured in such a way that it cannot slip or slide. Damage
resulting from sudden changes in speed (e.g. hard braking) is not covered under the terms of our
guarantee. Use the securing device supplied for this purpose.
CONNECTING TO THE POWER SUPPLY (FIGURE 1)
Before installation: Remove the positive terminal from the car battery fi rst in order to avoid short
Standard car wiring is normally not suffi cient for the power requirement of the integrated amplifi er.
Make sure that the wiring to the earth and +12V is of the correct gauge. 6 mm² cable is the minimum
requirement for the connection from the battery to the amplifi er terminals (for long cable runs over 4
meters, 10 mm² gauge cable should be used).
First make the connection between the amplifi er's earth terminal (3) and the negative terminal on the
battery. To ensure a good connection, any residual dirt should fi rst be carefully removed from the battery
terminals. A loose connection can result in malfunction or interference noise and distortions.
A power cable with an integrated fuse is then connected between the +12V (1) terminal on the amplifi er
and the battery's positive terminal. An additional fuse should be positioned at a maximum distance of 60
cm from the car battery. This is only to be inserted once all the installation work, including the connecting
of the speakers, has been completed.
Now connect the car radio's +12v remote control cable (P-con, Power Antenna, or similar) to the REM
(2) control socket on the amplifi er. A 0.75 mm² gauge cable is suffi cient for this REMOTE connection.
The REMOTE input is not connected if the active subwoofer is activated by the speaker output of a car
radio or an amplifi er, i.e. with high-level operation of the active subwoofer.
NF CABLE
When fi tting the audio cable in the vehicle between the car radio's cinch output and the cinch input on the
amplifi er, it should be ensured that the audio and power supply cables are, as far as possible, not laid on
the same side of the car. It is better to install these far apart from each other, i.e. the power cable in the
left cable duct and the audio cable in the right cable duct or vice versa. This reduces the feed-through of
interferences to the audio signal.
circuiting.
GB
5