Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To reduce the risk of fire, electric shock and injury:
•
Make sure that the power supply voltage corresponds to that indicated on the power supply value.
•
The adapter can be operated with AC 220-240V.
•
Do not use if the plug does not fit into the power outlet. Use an appropriate plug adapter for this case.
•
Do not pull the cable, do not bend, or place heavy objects on it.
•
Do not handle the plug with wet hands.
•
Do not use a damaged mains plug or a damaged socket.
•
Install this unit so that the power cord can be immediately removed from the socket, if a problem
occurs.
Inserting the battery fuse
•
Pull upwards to open the footboard and battery pack inside.
The small fuse box is located at the side next to the battery.
Take one of the fuses which is supplied in the tool set,
open the cap of the fuse box, insert the fuse and then close the
cap again.
Stow all of the cables and the small fuse box away at the side
next to the battery.
Close the battery compartment and snap the latches shut.
Check whether the latches have closed correctly.
The electrical parts
(Fuse, power supply, battery, charging unit)
•
If necessary, slide the saddle bar into the
saddle post (the narrow end must point up-
wards) and adjust it to the height you want.
Tighten up the quick-release lever.
•
Place the saddle on the saddle bar and ad-
just it to the optimum angle of inclination.
Tighten the two nuts using an open- jaw
wrench (size 13).
22
Werbung
Inhaltsverzeichnis
