Herunterladen Inhalt Inhalt Diese Seite drucken

Chal-Tec 500TT Bedienungsanleitung Seite 20

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

You will need an open-jaw wrench, size 10 and 13 and Allen keys size 5 and 6. If you do not have any
tools to hand, you can also use the tool set that is supplied. We recommend that you get help from a
second person when assembling the scooter.
Important - For all installation work on the vehicle: Be sure to turn off the engine and wear protective
gloves! The vehicle should be started only after complete assembly and after successful testing!
Raise up the steering rod. To do this, use one hand to press the lever down towards the foot board
and use your other hand to raise up the steering rod. Set the steering rod upright until you hear it
lock into place.
Check the tightness of the steering column by gentle shaking of the steering column.
Push the clamp to which the handlebar is attached onto the steering rod. Please note here that the
accelerator throttle must be positioned in the rider's right hand. The clamp must be flush with the
steering rod at the top, with only the ignition lock protruding out.
Align the handlebar in the correct position. Tighten the two screws in the clamp using an Allen key
(6 mm).
Mounting the speedometer
Screw the speedometer bracket from below onto the clamp (beneath the handlebar). You will need
an Allen key (5 mm) to do this.
Assembly
Raising up the steering rod
Mounting the Handlebar
20

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis