On Automation EC2AE Anweisungshandbuch Seite 22

14.2 PROGRAMMING OF STROKE SINGLE
Set the dip switch SW2-1 in ON position, START= push button connect with number 1 input or push button remote with the START
A - with the gate fully closed, enter into the programming pressing and release button SET until
LED DL3 flashes
C - pressing and release button START
D- The motor M1 start to opening
E - press and release START, to set the point of deceleration during opening of motor M1
F- when the leaf M1 reaches the mechanical stopper , after 3 seconds, press and release START
G- The gate automatically start to close and continues until it is completely close .
H- The DL3 shut off to indicate the end of the programming
14.3 PROGRAMMING AUTOMATIC RECLOSING:
A - with the gate fully closed, enter into the programming pressing and release button SET until
LED DL3 flashes
B - pressing and release button SET TX until LED DL3 flashes and it turns on the flashing light,
start the timer automatic reclose.
C - press and release the button SET TX, to stop the timer to set the automatic closing, the led DL3
and the flashing light are switched off
14.4 Disattivare la funzione di richiusura automatica:
A - with the gate fully closed, enter into the programming pressing and release button SET until
LED DL3 flashes
B - press and hold the SET button TX
ANWEISUNGSHAND - INSTRUCTION MANUAL
MOTOR:
22
SET
DL3
X 3 sec.
OPEN M1
OPEN M1
SLOWING DOWN
STOP OPEN M1
CLOSE M1
DL3
SET
DL3
X 3 sec.
SET TX
START TIMER
9 3
6
SET TX
STOP TIMER
12
9 3
6
SET
DL3
X 3 sec.
SET TX
DL3