Red Bull Racing SMR 49 Gebrauchsanweisung Seite 31

Cutting hair with comb attachment (2) or (3)
• Select one of the two comb attachments (2) or (3) and
attach it to the device as shown.
Make sure that you hear and feel the
comb attachment (2) or (3) click into
place. We recommend that you start
with the longest cutting length
initially on the comb attachment (2)
or (3) so you can then slowly work
your way up to your desired length.
• In order to adjust the cutting length on the comb
attachment (2) or (3), slide the sliding switch on
the rear of the comb attachment (2) or (3) to the
desired cutting length as shown.
• Press the ON/OFF button
operating display (10) begins to light up.
• Guide the device slowly through the hair. Ensure
that the comb attachment (2) or (3) sits as flat on the
head as possible.
• Always only trim small areas.
• Cut the hair against the direction of growth. If the
hair grows in different directions, use the device in
multiple directions.
• Press the ON/OFF button
device after use. The operating display (10) turns off.
Cutting hair without comb attachment (2) or (3)
If you want to cut your hair very short (0.5 mm to 2.5 mm), you can
use the device without the comb attachment (2) or (3).
• If a comb attachment (2) or (3) is attached to the device, pull the
comb attachment (2) or (3) upwards off the device.
• To set the precision adjustment level (8), use the
dial for precision adjustment (8) on the rear of the
device. You can now set the desired cutting length
to between 0.5 and 2.5 mm.
• Start the application.
1
(6) to switch on the device. The
(6) again to switch off the
31
3
2