Werbung
Verfügbare Sprachen
Verfügbare Sprachen
L 108 Mbps Wireless LAN PCI Card Quick Guide
You can check whether the wireless LAN card was installed properly under Start => Settings => Control
Panel => System => Device Manager => Network Cards. The entry "108 Mbps High Speed Wireless Network
Adapter" must appear without a yellow exclamation point.
Configuring the wireless LAN and the options of the utility
To start the utility, double click the symbol with the four bars at the bottom right of the screen beside the task
bar.
Options in the "Link Info" menu item:
If your WLAN device is connected to an access point or WLAN router, you can view information on the cur-
rent settings here. Click the "Rescan" button to update the information.
Options in the "Configuration" menu item:
SSID:
Name for the wireless LAN with up to 32 characters. It must be the same for
each device using the network.
Wireless Mode:
Infrastructure if used with an access point or router with wireless LAN
function. Ad-hoc if no access point or router with wireless LAN is used.
Ad hoc Band:
Speed standard can be selected in ad hoc mode 11A/11B/11G/11G Turbo
Channel:
Channel set for your WLAN network. The setting must be the same for the
entire network!
Tx Rate (11B/G):
Leave standard setting "Auto"
Tx Rate (11A):
Leave standard setting "Auto"
Power Mode:
Leave "Continuous Access Mode" standard setting
Preamble:
Leave "Short & Long Preamble" standard setting
Apply:
Apply changes
Cancel:
Cancel changes
Options in the "Advanced" menu item:
Encryption:
Enable: This activates encryption. We strongly recommend that you activate this option to
prevent unauthorised persons accessing your computer.
Auth. Mode:
Please set to "Auto".
Network Keys: You can select either "64 bits" or "128 bits" encryption strength here. We recommend that you
use the 128 bit setting.
Default Key:
In general, this should be left on the "1" setting
Key Format:
We recommend the "HEX" setting. The description below refers to this setting.
Enter your key in one of the 4 fields at the bottom.
Settings must be identical for each device in the network. Please make the corresponding settings before
you enter the key. If possible use a 128 bit (26 hex characters 0-9, A-F and a-f) key or 64 bit (10 hex
characters 0-9, A-F and a-f) key for configuration.
Examples:
128 bit key "645645645ed354a354caef45ae"
64 bit key "da64650c4f".
Click "APPLY" to apply the settings. Click "Cancel" to cancel the changes.
Options in the "Site Survey" menu item:
Networks in range are listed in this menu item. Click "Refresh" to scan again. To connect the card to a
wireless LAN, double click the network in question or select it and click "Connect".
Options in the "About" menu item:
Allows you to view the version of the driver, firmware and utilities.
Note:
This card may only be used in Germany, Austria, Switzerland, France, England, Belgium, Spain, Holland, Italy,
Denmark, Hungary, Poland, Sweden, Portugal, Luxemburg, Ireland, Greece and Finland!
See www.hama.de for the declaration of conformity with R&TTE Directive 99/5/EC.
0560
!
e
Werbung
