Silvercrest SWV 733 A1 Bedienungsanleitung Und Serviceinformationen Seite 326

SilverCrest SWV 733 A1
No LAN connection
 Check whether the network cable is inserted correctly into the WAN/LAN socket (6) or LAN socket
(7) of the dual-band wifi range extender and into the LAN socket of your end device.
Connection with the WPS button fails
 Establish the connection with the WPS button again.
 Reset the dual-band wifi range extender to its original condition. To do so, press the Reset button (5)
for approximately 3 seconds with a sharp object and then release it again. The LEDs then briefly go
out and this will reboot the dual-band wifi range extender. The dual-band wifi range extender requires
a certain amount of time (boot time) before it is ready to use. Wait for approximately 30 seconds
before using the dual-band wifi range extender. Then establish the connection with the WPS button
again.
 Eliminate sources of interference between the dual-band wifi range extender and the wireless router.
 The distance between the dual-band wifi range extender and the wireless router is too great, thus
reduce it.
The configuration menu of the dual-band wifi range extender is not shown.
 The address http://repeater.setup was entered into the address line of the Internet browser
incorrectly; check and correct the entry.
324 - English