Jetter JV-1005 Installationsanleitung Seite 11

Step
1
2
3
2
1
4
Panel cutout
Mounting
Action
Make a panel cutout for the
JV-1005 HMI.
Assemble the parts of the
supplied fastener set to
become four screw brackets.
Insert the HMI (1) with its
3 gasket (2) into the cutout (3) as
shown in the illustration.
Fix the HMI by means of the
screw brackets. Tighten the
screws, until the bezel is in full
contact with the surface.